Elegance Lighting Control

Comprehensive planning guide to installing the Elegance Lighting Control System. Includes an overview, product specs, installation diagrams, planning worksheets and other information you will use to plan an installation of the system.
Comprehensive planning guide to installing the Elegance XL Lighting Control System.
Gives Elegance wiring instructions for the U.S. market. Includes detailed photos and diagrams.
Gives Elegance wiring instructions for the Australian market. Includes detailed photos and diagrams.
Gives Elegance wiring instructions for the U.K. market. Includes detailed photos and diagrams.
Learn how to direct the Elegance Lighting Control System using the PC-based Progamming Software. Includes comprehensive instructions for basic and advanced functions including button captures, lighting scenes and timed events; system configuration and more.
Learn how to use the Elegance System. Provides an overview of the system and identifies components. Includes trouble-shooting tips.
Quick installation guide to integrating a low-volt fan speed control device with the Elegance Lighting Control System.
JetPak is an accessory package that integrates an Elk M1 Gold Home Autmation System with a hardwire Centralite System. Comprehensive guide to installing JetPak. Includes photos, diagrams and testing info.
See how to integrate a remote control receiver to the Elegance Lighting Control System.
The RCV-5000 is a programmable Infrared to RS232 receiver that allows remote controls to be used with both hardwire and wireless systems from Centralite.
Learn how to wire the lighted Finesse keypads into Elegance Systems.
Learn how to adjust the Elegance or LiteJet Systems for to set properly for Daylight Savings Time. The US will begin on the second Sunday of March and end the first Sunday in November beginning in 2007. In order to change the Daylight Savings start and end Sunday on your Elegance or LiteJet system, firmware (Version 7.0 or greater) is required. Also required is Elegance Programming Software (version 2.90.6 or greater) or LiteJet Programming Software (version 2.01.01 or greater) to adjust the start and end date of Daylight Savings.
Learn how to install a key fob remote receiver using the Quick Connect Board.
Explains how the Elegance System communicates in with third-party products.

JetStream Lighting Control

Learn how to install and program the JetStream System. Includes an introduction to the system, product specs, regulatory codes, installation diagrams, descriptions of options, as well as basic and advanced programming techniques.
Provides wiring information for both devices.
Learn how to install the motion sensor option. Programming information included.
This document will explain how to discover, capture and configure a RS-232 Bridge into a JetStream network, setup timed events, and explain the use of JetStream's third-party protocol.
The RCV-5000 is a programmable Infrared to RS232 receiver that allows remote controls to be used with both hardwire and wireless systems from Centralite.
This application note describes the equipment and setup needed to interface an HAI Omni LT, Omni II, or OmniPro II system with a Centralite JetStream system. The interface is made via a RS-232 connection between the HAI controller and the JetStream RS-232 Bridge using HAI Part No. 36A05-4.