Knowledgebase
Centralite.com | All together now > CentraLite Help Desk > Knowledgebase

Search help:


» Category: Elegance Programming  (Go back)

» Articles in this category:

 
Where to Download Elegance Programming Software Article rated 4.0/5.0
Where can I download the latest Elegance programming software? Download here: 
Problems Connecting PC to MCP Article rated 3.9/5.0
My Elegance programming software is not connecting with the MCP. Make sure you have the right cable.  Use a straight-thru cable with the following pinout:PIN 2 to PIN 2PIN 3 to PIN 3PIN 5 to PIN 5Ano...
Elegance Timed Events Article rated 4.0/5.0
Can I program lights to turn on or off based on the time of day? Yes.  The Elegance MCP(Master Control Panel) contains an astromical clock.  This means that lighting scenes can be initiated at certa...
Control Multiple Lighting Loads from One Button Article rated 3.9/5.0
Can I use 1 keypad button to activate multiple lighting zones?
Elegance Third Party Control Protocol Article rated 3.9/5.0
Do you publish your third party control protocol? Yes.  Our protocol is available for download here.
Updating Daylight Savings Settings Article rated 4.0/5.0
How do you change the Daylight Savings times in LiteJet and Elegance?  LiteJet and Elegance are affected by the Daylight Savings change. StarLite is not affected. Attached, is a link to a document...
How Do I Change the Baud Rates for the 3rd Party Ports in Elegance? Article rated 4.0/5.0
I want to change the 3rd Party Serial port Baud Rate on the Elegance system. If you have Firmware version 5.30 or greater:
Elegance Programmng - RS232 Cable - Maximum length Article rated 4.0/5.0
Not having a laptop, I want to programme my Elegance MCP from my desktop PC. The two units are located about 8 - 10 metres apart. Am I going to encounter any problems if I try to connect the PC to the...
Cable for Programming Elegance MCP Article rated 3.9/5.0
What kind of cable do I need to connect my PC to the Elegance MCP(Master Control Panel)? Use a straight through RS232 cable with 1 end male and the other end female.  Only pins 2, 3, and 5 are used...
 

 
Powered by Help Desk Software HESK - brought to you by Help Desk Software SysAid